Yes—quick relocation and refit of window kit, sealing and drain re-setup.

Yes—if the inverter/generator is correctly sized for starting current and run load. We’ll estimate the requirement.

Every 2–4 weeks in dusty/monsoon seasons; quarterly deep service recommended.

We can supply/coordinate acrylic or ply inserts with professional sealing.

Yes, in many rooms it reduces reheat and improves comfort, especially with long/hot runs.

For small loads with proper venting and continuous drain. For 24/7 duty, commercial spot coolers are better—ask us.

Not always. Many portable units are sealed without service ports. If repair is uneconomical, we’ll recommend replacement options.

Plug/MCB rating, shared load, loose terminals, surge protection, or compressor faults. We test and size correctly (10A/16A as applicable).

Yes—pairing, scenes, voice, geofencing; plus IR controllers for non-smart models.

We adjust placement, vibration isolation, and flow settings; also propose hose insulation and night-mode routines.

Clogged drain path, kinked tube, faulty float switch, or very humid conditions. We clean, test the float, and set up continuous drain if needed.

Short and straight is best. Over-length or tight bends reheat the room and strain the unit. We follow model-safe limits.

Yes—using door kits or casement inserts with proper weatherstripping.

Single-hose units can create negative pressure that pulls hot air in. Dual-hose reduces this. We optimise what you have and advise upgrades where sensible.

Often venting/sealing is the culprit. We seal gaps, shorten/insulate the hose, and verify delta-T before recommending capacity changes.